When your drains slow to a crawl or sewage backs up into the basement, you need sewer line cleaning in Marietta, Georgia that actually clears the pipe, not just pokes a hole in the clog. We hydro jet the full line, camera-verify the result, and tell you honestly whether cleaning solved it or you need a repair. Same-day appointments across Marietta and Cobb County.
Sewer line cleaning in Marietta, Georgia is a plumbing service that scours the inside of your main sewer pipe to remove grease, scale, roots, and debris so wastewater flows freely to the city main. We start with a sewer camera inspection to see exactly what is blocking the line and how bad the pipe condition is. Then we run a high-pressure hydro jetter through the cleanout, cutting through buildup with 3,000 to 4,000 PSI of water. Finally, we camera the line again to confirm it is clear and note any cracks, bellies, or offset joints that need attention.
Most Marietta homes we service were built between the 1950s and 1990s, which means clay tile sewer pipe, cast iron, and Orangeburg pipe are still common underground. Tree roots from mature oaks and pines along Whitlock Avenue and the Historic Marietta district find their way into clay pipe joints within a few years. If you are searching for sewer line cleaning near me in Marietta Georgia because your laundry drain gurgles or your toilets bubble, that is usually early root intrusion or grease buildup. Catching it with annual sewer line cleaning Marietta GA service prevents the 2 a.m. sewage backup that costs thousands.
Every cleaning job includes the steps that actually matter: diagnosis, full-pipe cleaning, and proof of the result. Here is what is covered in a standard visit, and what we quote separately if the camera shows you need it.
We push a sewer camera through the line and record the footage before any cleaning starts. You see the blockage, the pipe material, and any damage on the monitor. This takes 15 to 20 minutes and it is what tells us how much pressure the pipe can safely take.
We run the hydro jetter from the cleanout to the city main, scouring the full pipe wall at 1,500 to 4,000 PSI depending on pipe material. Grease, roots, scale, and grit get flushed ahead of the nozzle. Most residential lines take 45 to 90 minutes.
After jetting, we camera the line again and confirm it is clear wall to wall. If root mass remains, we make another pass at no extra charge. You get the video file and a written summary of the pipe condition before we leave.
We inspect your exterior cleanout, replace a broken cleanout cover, and clear any obstruction in the cleanout itself. If you have no cleanout, we quote installation separately because it requires locating the line and a small excavation.
You get a plain-language report noting pipe material, distance to any defects, and whether the line is a candidate for lining or replacement. If cleaning solved the problem, the report says so. If it did not, you get repair options with pricing.
We ask what is backing up, where, and when it started. Multiple fixtures backing up at once points to a main line blockage; one slow drain is usually a branch clog. That five-minute call tells us whether to bring a drain snake auger or go straight to the hydro jetter, and it lets us quote a realistic range before we roll.
We find your exterior cleanout, usually within 10 feet of the foundation. If the cleanout cover is broken or buried, we locate the line with a sewer line locator transmitter and may need to install a new cleanout. A working cleanout is required for proper main sewer line cleaning Marietta GA and it makes every future service faster.
Before cleaning, we push a sewer camera down the line and record the footage. You see the blockage, the pipe material, and any damage on the monitor. This step takes 15 to 20 minutes and it is what separates a real diagnosis from a blind snake job. We note the distance to any problem so you know exactly where it sits under the yard.
We feed the hydro jetter hose through the cleanout and work it downstream toward the city main. Water pressure scours the full circumference of the pipe, flushing grease, roots, and grit ahead of the nozzle. A typical residential line takes 45 to 90 minutes. We work in sections on longer runs and use a vacuum truck to capture debris when the line is heavily loaded.
After jetting, we run the camera again to confirm the pipe is clean wall to wall. If we see remaining root mass, we make another pass. If we see a crack, a belly, or separated joints, we show you the footage and explain your options, from spot repair to trenchless sewer repair. You get the video file and a written summary before we leave.
We ask what is backing up, where, and when it started. Multiple fixtures backing up at once points to a main line blockage; one slow drain is usually a branch clog. That five-minute call tells us whether to bring a drain snake auger or go straight to the hydro jetter, and it lets us quote a realistic range before we roll.
High-pressure water cleaning from 1,500 to 4,000 PSI. We adjust pressure by pipe material so we scour the wall without cracking clay tile or Orangeburg pipe.
Video inspection before and after cleaning. We record footage, measure distance to defects, and show you the screen so you see what we see.
Used for branch drains and light blockages where jetting is not needed. Also useful for clearing a path so the camera can pass through a heavy clog.
Marks the path of the sewer line underground so we can find buried cleanouts and pinpoint the location of defects before any digging.
Captures heavy debris, grease, and root material flushed out during jetting so it does not load the city main or back up into your home.
Clears obstructed cleanouts and lets us isolate sections of line for pressure testing or lining work after cleaning is complete.
A 1965 ranch home had backed up three times in 18 months. Each time, a hand snake cleared it for a few weeks. The camera showed a root mat 28 feet from the cleanout, filling about 70 percent of the clay tile pipe.
After: We jetted the line at 3,500 PSI with a root-cutting nozzle, flushed the debris, and cameraed again. The pipe was clear wall to wall. Flow restored to full diameter, and the homeowner has gone 14 months without a backup.
Book this service →
A restaurant on the Square was snaking its kitchen line monthly and still getting slow drains during dinner service. The camera showed heavy grease scale narrowing the 4-inch line to about 2.5 inches across a 40-foot run.
After: Two passes with the hydro jetter at 4,000 PSI restored the full 4-inch diameter. We pulled out roughly 30 gallons of grease and debris with the vacuum truck. The kitchen has run six months without a slowdown.
Book this service →
Sewage backed into a basement on a Sunday night. The line was completely blocked. The camera showed a collapsed section of clay tile pipe about 12 feet from the foundation, with soil entering the pipe.
After: We jetted what we could to restore partial flow, then performed a spot repair on the collapsed section the next morning. Flow was fully restored within 24 hours of the call, and the basement was cleaned and dried.
Book this service →Most sewer calls come down to a handful of root causes. Here is what we find most often and how cleaning addresses each one.
Ask a pro →We cut the roots out with a high-pressure root nozzle, flush the debris to the city main, and camera the line to confirm it is clear. Then we recommend CIPP lining to seal the joints so roots cannot re-enter.
Hydro jetting at 3,000 to 4,000 PSI scours the full circumference and restores the pipe's original diameter. We finish with a camera run so you can see the clean wall, and we set you up on a maintenance schedule if you are a restaurant.
The camera shows us exactly where the low spot sits and how deep it is. If the belly is minor, cleaning buys time. If it is severe, we quote sagging sewer line repair or a spot replacement to restore proper slope.
When the camera shows Orangeburg, we switch to low-pressure cleaning only if it is safe, and we quote replacement with PVC or HDPE. Most Orangeburg lines in Marietta are past their service life and need to come out.
$180 - $650 for most residential sewer line cleaning jobs
Typical 2026 pricing for sewer line cleaning in this area runs $180 to $650 for residential lines, with most jobs landing between $300 and $450. The price depends on line length, blockage type, and access. We quote a flat rate before we start, and camera inspection is included. If the camera shows you need a repair instead of a cleaning, we tell you that before you spend money on jetting a pipe that cannot be saved.
A $300 cleaning that prevents a $5,000 sewage backup and basement cleanup pays for itself many times over. We quote flat, include the camera, and never charge for a second pass on the same visit if roots remain.
A 30-foot lateral from a cleanout near the foundation is quick work. A 90-foot run to the city main with a buried cleanout takes longer and may need line locating first. Longer runs and poor access raise the price.
Get a quote ↗Grease and soft debris jet out in one pass. Heavy root mats need a root-cutting nozzle and multiple passes, which adds time. Collapsed pipe or heavy scale may require a second visit.
Get a quote ↗PVC cleans fast at full pressure. Clay tile and cast iron need lower pressure and more passes. Orangeburg pipe may not be safe to jet at all, which changes the job from cleaning to replacement.
Get a quote ↗A working cleanout keeps the job simple. A broken, buried, or missing cleanout means we locate the line and install a new one first, which adds a separate line item to the quote.
Get a quote ↗Most residential sewer line cleaning in Marietta runs $180 to $650 in 2026, with a typical single-family job landing around $300 to $450. Price depends on line length, blockage type, and whether we need to install a cleanout. Root-heavy mains and commercial lines run higher. You get a flat quote before we start, and camera inspection is included in the price.
Every 18 to 24 months is right for most Marietta homes with mature trees nearby. If you have clay tile pipe, cast iron, or a known root problem, annual sewer line cleaning Marietta GA service is the safer schedule. Homes with PVC pipe and no tree issues can stretch to three years. We note your pipe material and root risk on the invoice so you know your interval.
Yes. A hydro jetter with a root-cutting nozzle at 3,500 to 4,000 PSI slices roots at the pipe wall and flushes them out. It removes the growth inside the pipe, but it does not seal the joint the roots came through. For a permanent fix on clay tile sewer pipe, we recommend CIPP lining or pipe bursting after cleaning so roots cannot re-enter.
A drain snake auger cuts a channel through the clog, so water flows but grease and roots remain on the pipe wall and rebuild fast. Hydro jetting scours the full circumference and restores the pipe's original diameter. Snaking is fine for a single branch drain; main sewer line cleaning Marietta GA jobs should be jetted and camera-verified for results that last.
Licensed, insured, and camera-equipped. We quote a flat price before we start and show you the before-and-after footage. Call now and we will get a truck to your cleanout, often the same day.
Schedule Service +14707391979 →Reach out for fast, friendly service. We're available 24/7 for emergencies and can schedule regular appointments Monday through Friday. Call us at +1 470-739-1979 or email [email protected]. We serve all of Marietta and surrounding areas.