Sewer line tree root removal in Marietta, Georgia means cutting the roots out of your lateral, then repairing the joint or crack they grew through. We handle both. If your drains are slow, gurgling, or backing up into a tub, roots are the usual suspect. We camera the line, show you the footage, and clear it the same day.
Sewer line tree root removal in Marietta, Georgia is the process of cutting, extracting, or dissolving root masses that have entered your sewer lateral through joint gaps, cracks, or failed seals, then restoring the pipe so roots cannot re-enter. Roots do not break pipe on day one. They slip through a hairline gap at a clay tile joint, feed on the warm water and nutrients inside, and expand until the line is half blocked. By the time you notice a backup, that root ball has usually been growing for two or three seasons.
Most Marietta calls we run start the same way: a homeowner on Whitlock Avenue or near Marietta Square has a downstairs toilet that gurgles when the washer drains, or a cleanout that spills after a heavy rain. If you are searching for sewer line tree root removal near me in Marietta Georgia, the fix is not a bottle of foaming root killer. It is a camera inspection, a mechanical cut, and a permanent repair at the entry point. We do all three in one visit whenever the pipe is still structurally sound.
Every root job starts with a camera inspection and ends with a clean, verified line. If the pipe needs more than a cut, we tell you before we start. Here is what is covered in a standard root removal visit.
We run a push rod camera from the cleanout to the city main and record the footage. You see the root mass, the entry point, and the overall pipe condition. The recording is yours to keep, which matters if you are selling the home.
We cut roots with a sectional machine and root-cutting head, working the full length of the lateral. Heavy intrusions get a second pass with a chain cutter. This removes the root structure, not just a channel through it.
After cutting, we jet the pipe at 3,000 to 4,000 PSI to scour the wall and push debris to the city main. This step is what keeps the line clear longer than a snake job would.
We re-camera the line after jetting and show you the clean pipe. If roots or debris remain, we run the cutter again. You do not pay for a job we cannot show you on camera.
If the footage shows a cracked joint, offset, or collapsed section, we quote the repair on the spot: spot repair, pipe lining, or replacement. You decide, and we schedule it when you are ready.
We start at the cleanout and run a push rod camera down the lateral. You watch the monitor with us. We mark the depth of the root intrusion with a sewer line locator transmitter so we know exactly where it sits under the yard. This step takes 20 to 30 minutes.
Once we see the footage, we tell you what the job takes: a straight root cut, a cut plus spot repair, or a full replacement if the pipe is collapsed. You get the number before any work starts. No surprise line items after the fact.
We run a RIDGID or General Pipe Cleaners sectional machine with a root-cutting head through the line, working from the cleanout toward the city tap. Heavy root balls get a second pass with a Picote chain cutter. Most cuts take 45 to 90 minutes.
A hydro jetter at 3,000 to 4,000 PSI scours the pipe wall and pushes the cut roots, grease, and grit out to the city main. This is the step that separates a real root removal from a quick snake job. We re-camera afterward to confirm the line is clean.
If the camera shows a cracked joint, offset, or separated clay tile, we repair it the same day with a spot repair, pipe coupling, or cured-in-place pipe liner. Then we talk prevention: what to plant, what to keep away from the lateral, and whether a backwater valve makes sense for your property.
We start at the cleanout and run a push rod camera down the lateral. You watch the monitor with us. We mark the depth of the root intrusion with a sewer line locator transmitter so we know exactly where it sits under the yard. This step takes 20 to 30 minutes.
We inspect the lateral from the cleanout to the city main and record the footage. The camera shows us the root mass, the entry point, and any pipe damage before we cut anything.
Our primary root cutter. It drives a root-cutting head through the lateral and slices the root mass at the pipe wall, working from the cleanout toward the city tap.
For heavy root balls and hard mineral buildup, the chain cutter grinds the obstruction down without damaging sound pipe. We use it as a second pass after the sectional machine.
A 3,000 to 4,000 PSI jetter scours the pipe wall after cutting and flushes roots, grease, and grit out to the city main. This is what makes the result last.
We send a transmitter down the line and mark the depth and path of the lateral on the surface. That is how we keep any excavation small and targeted.
When a spot repair or replacement is needed, the mini excavator opens a small, precise trench instead of tearing up the whole yard. Most repairs use a footprint under 6 feet long.
A homeowner near Marietta Square had two backups in eight months. A previous company snaked the line both times. The camera showed a root mass at a separated clay tile joint about 22 feet from the cleanout, with the pipe roughly 60 percent blocked.
After: We cut the roots with a sectional machine, jetted the line at 3,500 PSI, and installed a cured-in-place pipe liner over the damaged joint. Flow was fully restored the same day, and the camera footage after lining showed a smooth, sealed pipe.
Book this service →
A West Marietta home had a downstairs toilet gurgling whenever the washer drained. The camera showed roots entering through a corroded cast iron joint, plus heavy scale on the pipe wall reducing flow even without the roots.
After: We cut the roots, jetted the scale off the pipe wall, and replaced the corroded joint with a new coupling and a short liner section. The gurgle stopped immediately, and a post-job camera pass showed a clean, round pipe.
Book this service →
Sewage backed into a basement in East Marietta on a Sunday evening. The cleanout was overflowing and the lowest floor drain was backing up. The homeowner had no idea roots were the cause until we arrived.
After: We cleared the line with a root cutter and hydro jetter, restoring flow before midnight. The camera showed a root mass at a clay joint plus a small bellied section. We quoted a spot repair the next morning and completed it that week.
Book this service →Roots cause a specific set of failures, and each one has a different fix. Here is what we see most often on Marietta laterals and how we handle it.
Ask a pro →We cut the full root structure, jet the pipe wall clean, and camera the line to find the joint the roots entered. If that joint is cracked, we repair or line it so the same tree cannot re-enter next season.
We respond 24/7, clear the line with a root cutter and hydro jetter, and camera the lateral to confirm the blockage is gone. Then we quote any repair the roots made necessary, so it does not happen twice.
A camera inspection tells us in 20 minutes whether roots, grease, or a bellied pipe is the cause. If it is roots, we cut and jet the line the same visit and show you the before-and-after footage.
We remove the root mass mechanically and address the entry point with a spot repair, pipe coupling, or cured-in-place pipe liner. Sealing the joint is what actually prevents the return.
$350 - $900 for standard root removal; $750 - $2,100 with spot repair or lining; $4,500+ for full lateral replacement
Typical 2026 pricing for sewer root removal in Marietta runs $350 to $900 for a standard residential job, including camera inspection, mechanical cutting, and hydro jetting. If the camera shows a cracked joint or separated clay tile that needs repair, add $400 to $1,200 for a spot repair or short liner. Full lateral replacement, when the pipe is collapsed or Orangeburg, starts around $4,500. We quote before we start, and the number does not change after the fact.
Cutting roots is cheap. Ignoring them is not. A $400 root job today prevents a $9,000 replacement later, and a camera inspection at the same visit tells you exactly which outcome you are facing.
Deeper lines take longer to access and require more equipment setup. A lateral 6 feet down costs more to service than one at 3 feet, and depth also affects the cost of any repair or replacement.
Get a quote ↗A single root mass at one joint is a straightforward cut. Roots at multiple joints, or a full-length intrusion, take longer to cut and jet, and they usually mean the pipe needs a liner or spot repair to stop the cycle.
Get a quote ↗Clay tile and cast iron can often be cut and repaired. Orangeburg pipe is a different story, because it deteriorates from the inside and often needs replacement rather than repeated root cutting. We tell you which you have from the camera footage.
Get a quote ↗A working two-way cleanout at the property line makes the job faster and cheaper. If the cleanout is broken or missing, we install one first, which adds to the visit but saves money on every future service.
Get a quote ↗Most residential root removals in Marietta run $350 to $900 in 2026, including camera inspection and hydro jetting. If the camera shows a cracked joint or separated clay tile that needs a spot repair, add $400 to $1,200. Full lateral replacement, when the pipe is collapsed, starts around $4,500 and goes up with depth and driveway restoration.
Yes, in most cases. We cut roots mechanically through the existing cleanout and jet the line clean, with zero excavation. Digging only becomes necessary when the pipe itself has collapsed or the root entry point needs a spot repair that a liner cannot bridge. Roughly eight out of ten Marietta root jobs we run are completed without opening the yard.
Willows, silver maples, river birches, and sweetgums are the worst offenders around Marietta, and the older neighborhoods near Marietta Square and Whitlock Avenue are full of them. These species send roots 20 to 30 feet toward moisture. Even a tree 15 feet from your lateral can find a clay tile joint and work its way in within a few seasons.
No. Foaming root killer kills the roots it touches, but the dead mass stays in the pipe and the same tree regrows into the same joint the next season. It is a maintenance product, not a repair. If roots are already causing backups, you need mechanical removal and a camera inspection to see what the roots damaged on the way in.
Slow drains and gurgling toilets turn into sewage backups fast. We are licensed, we camera every line before we quote, and we clear roots the same day in most cases. Call now and we will tell you what your line needs.
Book Root Removal +14707391979 →Reach out for fast, friendly service. We're available 24/7 for emergencies and can schedule regular appointments Monday through Friday. Call us at +1 470-739-1979 or email [email protected]. We serve all of Marietta and surrounding areas.